Kjellberg Machine Plasma.
Kjellberg HiFocus 130
Plasma cutting unit with PLUS technology.
  • HiFocus 130Plasma cutting with laser-like quality (HiFocus) between 0.5 and 30 mm with HiFocus PLUS technology for mild steel
  • Cutting of stainless steel (HiFinox technology) from 1 to 6 mm and from 3 to 40 mm with HiFocus F technology
  • Cost saving alternative compared with laser cutting with less than a quarter of the expenses for investment and operating
  • CNC-controlled cutting with plasma machine torch and oxygen, nitrogen or argon/hydrogen as plasma gas
  • Low squareness and inclination tolerances of cutting surfaces
  • Precise contour at sharp edges and narrow radii
  • Hole cutting of small diameters
  • HiFocus technique guarantees a high fitting accuracy
  • No or small dross formation depending on material
  • High life-time of consumables by dual-gas ignition and nozzle saving piercing with swirl-gas technique
  • CNC interface for all kind of 2D- and 3D-CNC-guiding systems
Power source HiFocus 130:
  • Optimum process run by microprocessor control
  • Monitoring of process sequence (torch cooling, ignition time, pilot arc time, short circuit time during torch ignition, power source and so on)
  • Display of operating conditions, with malfunction indication and display
  • Extensive interface for adaptation to CNC control
  • Serial data transfer for PC diagnostic
  • Step-less current setting for HiFocus quality from 20 - 130 A by switchable pilot current
  • Optimum piercing by step-less time delay for main arc and adjustable current rise within 4 steps
  • Adjustable down-slope at corner, start and end signals from the guiding system
  • Digital display of current and voltage
  • Automatic display of pre-set cutting current
Plasma torch PerCut 160/170:
  • Plasma machine torch PerCut 160/170 with new beam production system ensure a stable main arc
  • Long life-time of consumables by water cooling
  • Hose parcel extensions 10 m, 20 m, 30 m or 40 m and plasma ignition box ensure a cutting range up to 55 m
  • Step-less gas control ensures optimum gas parameters for cutting
  • Special torches (robot, short or/and inclined torches) are available for special applications (i.e. pipe cutting from inside)

Technical data:

Mains voltage (V) 3x 400 (50 Hz)
Fuse, slow (A) 50
Connecting power (kVA) 32
Automatic cut-out A 50 "K"
Protection class - IP 22
Open circuit voltage (V) 400
Cutting current (A) 20 - 130 (step-less)
130 A / 100% d.c.
Piercing with height sensing system mm 25
Cutting thickness
- maximum
- recommended
(mm) 40 (material depending)
30 (material depending)
Plasma gases - Air, Oxygen, Argon, Nitrogen, Hydrogen
Swirl gases - Oxygen, Nitrogen, F5
Cooling - Fluid (Kjellfrost)
Ignition - High voltage
Weight (kg) 251
Dimensions L x W x H (mm) 960 x 540 x 1050